Uniform bearing surface with maximum 1/4” gap
9 5. Axial load-bearing studs must be fully seated into the wall tracks (1/16" maximum gap between the studs and the track webs). Fasteners are not designed to ...
light gauge components, and should be
Hello Engineers: AISI recommends a 1/8 gap (max) between the bottom of a bearing stud and it's track. What is the basis of this? So what ...
A universal designator system for Cold-Formed Steel Framing (CFSF)
Steel ‐ Cold‐formed sheet steel with thicknesses ranging from 97 mils (12 gauge) to 33 ... a uniform bearing surface with a maximum 1/4 inch gap between the bottom.
Maximum gap between end of header member and vertical face of clip shall not exceed 3/8 inch . 4.
Light-gauge steel and gypsum assemblies provide fast, lightweight, low-cost and
SCAFCO Slotted Track and Seismic Drift Track are the industry preferred
The light gauge metal stud framing phase of a project significantly impacts